Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Repair Across Glenside
Chimney repair in Glenside almost always starts with the same discovery: a brick stack that looks solid from the driveway is quietly failing on the inside. That’s especially true in the twins and colonials around 19038, where coal-era chimneys were converted to gas or wood without ever getting a proper liner. We repair the full system, not just the visible masonry, and we don’t quote a rebuild until a camera shows us what’s actually happening in the flue. Call (833) 350-7109 for a free estimate.
Why Glenside Homeowners Call Chimney Sweep Bustleton for Chimney Repair
We know Glenside’s housing because we work on it constantly. The brick exterior chimneys on Keswick Avenue, Easton Road, and the side streets off Mount Carmel Avenue are a particular type: solid-looking masonry outside, clay-tile flues inside that have spent decades taking moisture and flue gases from an appliance the chimney was never designed for. That mismatch is the root of most repair calls here.
Our technicians have up to 9 years of experience, and they’re trained to run a Level 2 inspection with a camera before recommending anything. If you’re on a block of twins, that matters. A repair scoped on one address can quietly affect the neighbor’s fireplace if the shared flue partition is cracked, and we check for that before we sweep.
When you call, we answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. We connect you with a licensed, insured local professional who performs the work – and the written estimate sets the final price.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Repair Services in Glenside
Mortar Repointing
Freeze-thaw is hard on Glenside’s older exposed chimneys. Cold, damp winters followed by repeated thaws work at the mortar joints above the roofline, and once a joint opens, water travels inward. Repointing replaces that failed mortar with a mix matched to the original brick so the chimney can move with the seasons instead of cracking. We repoint only where the joints are actually deteriorated, not the whole stack to pad a quote.

Spalling Brick Repair
Spalling is what you see when brick faces peel, flake, or pop off in layers, usually on the chimney’s weather side. In Glenside’s 1890s – 1920s stock, the culprit is often water that got behind the face brick through a cracked crown or failed flashing. We replace the damaged units and fix the water path that caused them, because new brick over a leak fails the same way in a few seasons.

Chimney Waterproofing
Waterproofing is the cheapest repair on this page and the one most often skipped. A breathable masonry sealer keeps liquid water out while letting the brick dry from the inside, which matters on a humid Philadelphia-area summer when creosote stays soft and the masonry is already damp. It doesn’t fix a cracked crown or open flashing – those get repaired first – but it slows the next round of spalling. We can also apply HeatShield resurfacing where the flue itself has eroded.

Flashing Repair
Flashing is the metal where the chimney meets the roof, and it’s the first place we look when a Glenside homeowner reports a ceiling stain after a storm. Spring is peak season for post-winter crown and flashing leak calls, and old step flashing that’s pulled loose or rusted through lets water straight into the attic. We reset or replace the flashing and seal it correctly to the roof, then confirm with a water test where the pitch allows.
Why Glenside’s Twin Chimneys Change How We Quote
Here’s the thing a lot of Glenside homeowners don’t find out until it’s too late. In the 1890s – 1920s twins along the 19038 corridor, a single chimney breast often carries two separate flues side by side, sharing one stack. That’s a layout you rarely see in detached suburban housing, and it means a repair scoped on one address can silently affect the neighbor’s fireplace if the shared flue partition is cracked or one side’s flue has come disconnected. Sweep one side without checking, and soot can drop into the firebox next door. Our technicians check for a disconnected or shared flue before they sweep, and they scope both sides when the stack is shared. This is the kind of local condition that separates a careful repair from a callback.
How a Typical Chimney Repair Job Goes in Glenside
On Glenside’s early-20th-century twins, a winter of freeze-thaw cycles typically opens hairline cracks in the mortar crown, and water migrating down through spalling brick reaches the clay-tile flue and the smoke chamber below. A qualified local technician runs a Level 2 inspection with a camera before quoting anything, confirms whether the stack is unlined or only partially relined from its coal-to-gas conversion, and repoints or rebuilds the crown and brick only where the footage shows actual deterioration. Then comes the shared-flue check, so sweeping one side doesn’t drop soot into the neighboring unit. If your chimney has never been scoped, that inspection is the first thing we do.
Trusted Brands We Service in Glenside
When a repair calls for a liner, cap, or resurfacing, the material matters as much as the labor. We install and work with DuraFlex flexible liner systems, a professional-grade product built for long-term performance, and we’re certified to apply HeatShield chimney resurfacing – a repair method that restores liner integrity without full replacement. We source components through Olympia Chimney and Copperfield, two well-respected supply networks in the trade. That means the right material for the repair, specified by name, not a generic big-box substitute. We don’t stock parts on a truck; we spec the right component for your stack and get it to the job.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Repair Problems We See in Glenside Homes
- Unlined or partially relined coal-era stacks. Chimneys built for coal and later converted to gas or wood were never lined for the higher flue-gas temperatures and moisture those appliances produce, so the brick gets attacked from the inside while the exterior still looks fine.
- Spalled brick and cracked crowns from freeze-thaw. Repeated winter thaw cycles open the mortar crown and flake the brick faces on exposed chimneys, letting water into the flue-tile joints and the smoke chamber underneath.
- Cracked or disconnected shared flues in twins. Two flues in one stack can lose their partition or a flue connection, which means sweeping one side can dump soot into the neighbor’s firebox – a failure mode unique to attached housing.
- Failed flashing at the roof line. Old step flashing pulls loose or rusts through, and storm water finds the attic; this is the most common spring call we get in Glenside.
Pricing for Chimney Repair in Glenside, PA
Repair pricing in Glenside runs higher than in newer suburbs because the work is usually corrective, not cosmetic – you’re fixing a coal-era stack that was never upgraded properly. Here’s what our typical ranges look like:
- Mortar repointing: $350 – $900, depending on how much of the stack is above the roofline.
- Spalling brick repair: $400 – $1,200, based on the number of units replaced and the water source behind them.
- Chimney crown repair or rebuild: $500 – $1,500.
- Flashing repair: $300 – $700.
- Chimney rebuilding (partial): $2,500 – $6,000.
These are estimated ranges, and the written estimate you get after the inspection sets the final price. The estimate is free, the flat price is agreed before any work is booked, and the camera inspection with a photo report is included so you can see exactly what we’re repairing. Call (833) 350-7109 to schedule.
We Also Serve Cities Near Glenside
The same chimney repair service covers the towns around Glenside. If you’re in Roslyn, Jenkintown, Rockledge, or Elkins Park, we can help there too, and the housing stock and the climate are close enough that the same repair logic applies. If you’d like to know more about our full-service approach across the region, see our chimney repair page, or read more about how we serve Glenside and the surrounding area.
Serving Glenside, PA – Our Local Coverage Area
We serve Glenside and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Repair in Glenside
You know by having the shared stack scoped on both sides before anyone touches it. We check the flue partition and each flue connection at the inspection, and we include the camera footage in the photo report so you and your neighbor can both see the condition. If the partition is cracked or a flue is disconnected, that gets repaired or isolated before we sweep, so soot can’t drop into the neighboring firebox. Call (833) 350-7109 for an exact quote on the shared-stack inspection.
Not always, and that’s exactly why we scope it first. Many coal-era chimneys were left unlined or only partially relined during the conversion, and gas appliances produce moisture that attacks the brick from inside. The camera tells us whether the existing flue is sound enough to keep or whether it needs a liner – often a DuraFlex flexible system – and the footage lets you verify the call before you agree. Call (833) 350-7109 for a free estimate.
Because freeze-thaw cycles here open hairline cracks in a mortar crown, and once water gets in, the next freeze pushes them wider. A crown that’s simply patched crack-over-crack keeps failing; the lasting fix is a crown rebuilt with the right slope and overhang so water sheds off the top instead of settling. We repair or rebuild only where the inspection shows deterioration. Call (833) 350-7109 to book an inspection.
Yes – by looking at it, not by guessing from the outside. Third-degree creosote is the glazed, hardened layer that bonds to the flue walls, and it’s confirmed with a camera in the flue during the inspection. That matters because the wrong chemical treatment wastes money and the right mechanical removal is a different job. We show you the footage so you can see the condition yourself. Call (833) 350-7109 for an exact quote.
It needs the camera evidence behind it – a Level 2 inspection with a photo report you can review, not a verbal “you need a rebuild.” A fair quote also states whether the stack is lined or unlined, itemizes the repair (repointing, crown, flashing, liner) instead of bundling it into one lump sum, and sets a flat price in writing before the work is booked. If a contractor can’t show you footage, don’t agree. Call (833) 350-7109 for a free estimate.
Get a Free Chimney Repair Estimate in Glenside
Whether your chimney needs a few repointed joints or a crown rebuild, the first step is the same: a real look at what’s going on inside the stack. Call (833) 350-7109 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Our technicians have up to 9 years of experience, and you’ll see the camera footage before you agree to a single repair.
Written by the team at Chimney Sweep Bustleton.