Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Elkins Park
If your Elkins Park chimney crown is cracked, or your flue is open to rain, squirrels and leaf debris, a proper cap and a sound crown are the two parts of the system that stop water before it starts. We handle the full system, not just the sweep. In Elkins Park’s older homes, most of what looks like a “chimney problem” starts at the top: a flat mortar crown that has sheared at the flue tile joint, or a cap that never fit the flue it went over. Our technicians have up to 9 years of experience, and we work from a camera scan and a written estimate rather than a guess. Call (833) 350-7109 for a free estimate.
Why Elkins Park Homeowners Call Chimney Sweep Bustleton for Chimney Cap & Crown
Elkins Park has a particular chimney profile. The large stone and brick Tudors, Colonials and Victorians that define the area were built between the 1890s and the 1930s with tall, ornate stacks, and many of those stacks still have their original coal-era flues. Some have no liner at all. Some have a clay tile that has seen a century of damp winters. Converting those old flues to a gas furnace or an oil boiler puts a modern appliance into a stack that was never designed for it, and that’s where liner and creosote problems live.
We know this because it’s the shape of the work here. When we look at a chimney on a property off Church Road or near the Biddle estate grounds, we’re usually looking at a crown problem that has already sent meltwater behind the masonry. Cold, wet winters and humid summers in this Philadelphia suburb drive freeze-thaw damage hard, and a cracked crown is the open door. Heavy spring pollen and leaf fall make it worse by loading up the flue with debris that holds moisture.
What that means for you: nothing gets recommended without camera evidence you can see for yourself. If the liner is sound and only the crown needs re-forming, we’ll say so. If a crown coating is the honest fix and a rebuild isn’t, we’ll say that too. Elkins Park homeowners ask real questions, and we answer them before we quote.
We’re also mindful of the local historical society’s discouragement of exterior alterations. Much of our cap and crown work in Elkins Park is sized and fitted to preserve the ornate facade while still meeting modern venting codes. That usually means working from inside the flue where possible and choosing a cap that reads as part of the stack rather than an add-on.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Elkins Park
We focus on the sub-services that actually solve the water and animal intrusion problems in Elkins Park’s older stacks. Custom Cap, Crown Repair and Multi-Flue Cap get most of the calls, and Cap Installation and Crown Coating round out the range.
Custom Cap Installation in Elkins Park
A custom cap is the right answer when the flue openings aren’t a standard size, which is most of Elkins Park. These older homes were built around rectangular clay tiles in odd dimensions, and a one-size cap leaves gaps at the corners. We measure the actual flue tile, then specify a cap built to fit it. We work with Gelco and Famco caps, purpose-engineered products rather than generic covers.

Cap Replacement in Elkins Park
Plenty of Elkins Park stacks already have a cap, and it’s the wrong one: a round cap forced onto a rectangular clay tile, or a rusted out unit that’s no longer doing its job. We replace it with something sized to the opening, so squirrels and rain stay out and the flue can breathe. We’ll show you the fit on camera before we install.

Crown Repair in Elkins Park
The crown is the mortar slab on top of the chimney, and on a tall Victorian stack it takes the most weather of anything on the house. When it shears at the flue tile joint, meltwater gets behind the brick and freeze-thaw cycles spall the face. Crown repair rebuilds that slab with a proper overhang and expansion joint so water sheds away from the masonry instead of into it. This is the single most common fix we make on Elkins Park chimneys.

Crown Coating in Elkins Park
A crown coating can extend the life of a sound crown, but only when the surface underneath is prepped and clean. On Elkins Park chimneys we often find coatings applied over soot-darkened or friable mortar, and they fail within a season, trapping moisture and hiding damage beneath. We prep properly and use HeatShield resurfacing where it’s the right call. If coating isn’t the fix, we’ll tell you why.
Trusted Brands We Service in Elkins Park
We work with professional-grade products because they last longer and fit better than hardware-store substitutes. That means Gelco and Famco caps, HeatShield for resurfacing, DuraFlex flexible liner systems where a reline is needed, and Olympia Chimney and Copperfield components. We don’t keep a parts stock and we don’t carry a warehouse; we specify and source the right component for your chimney and schedule the work. If your stack needs a cap sized to the original flue tile openings, we’ll order it fitted, not adapted. Fast turnaround on most jobs.
Common Chimney Cap & Crown Problems We See in Elkins Park Homes
The failures here tend to repeat. These are the ones that show up most on Elkins Park’s Tudor, Colonial and Victorian stacks.
- Sheared mortar crowns on tall stacks. Original crowns crack at the flue tile joint and send water into unlined coal-era flues. Once it’s inside, freeze-thaw cycles spall the exterior brick face.
- Wrong-sized caps on rectangular clay tiles. Single-flue caps made for modern round liners get forced onto rectangular tile, leaving corner gaps. Squirrels and rain get in, and the cap never seals.
- Coatings over friable mortar. A coating applied over a soot-darkened or crumbling crown fails fast, traps moisture, and hides the damage underneath. We always check the substrate first.
- Unlined coal-era flues venting modern appliances. A gas furnace or oil boiler routed into an original flue with no liner is a different problem than a cap issue, and it needs a camera scan to diagnose. We won’t recommend a reline without showing you the evidence.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Cap & Crown in Elkins Park, PA
Here’s what the work typically runs in Elkins Park. A standard single-flue cap installation runs $250-$480. A custom cap sized to a rectangular clay tile opening runs $400-$800, depending on flue count and how ornate the stack is. Crown repair, including a rebuilt slab with proper overhang and expansion joint, runs $450-$1,100 for a typical Elkins Park chimney. Multi-flue caps run $600-$1,400 depending on how many openings need covering. Crown coating alone runs $200-$450 where the crown is sound. What moves the number: the number of flues, the height and access, and whether the crown needs a full rebuild or just re-forming. The written estimate sets the final price, and the estimate is free. Call (833) 350-7109 to book a look.
We Also Serve Cities Near Elkins Park
We work across the surrounding towns as well. If you’re in Jenkintown, Rockledge, Glenside or Roslyn, the chimney profile is similar: older masonry stacks, original crowns, and flue openings that don’t match a standard cap. We serve Elkins Park and these neighboring towns with the same camera-first approach and the same sizing discipline. One call covers the full system, whether it’s a cap replacement or a crown rebuild.
Serving Elkins Park, PA – Our Local Coverage Area
We serve Elkins Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Elkins Park
Yes. A cap can be fitted to an unlined coal-era flue without any change to the chimney facade. The cap sits on top of the flue tile or is clamped to it, and the work happens at the crown, not on the exterior face. For Elkins Park homeowners worried about the historical society’s guidance, a properly sized cap reads as part of the original stack, not an addition. We’ll show you the fit before we install. Call (833) 350-7109 for an exact quote.
You know it needs rebuilding when the camera or a hands-on look shows a crack through the crown slab or a gap at the flue tile joint, not just surface wear. A coating only works on a sound crown with a clean surface. On Elkins Park chimneys, we regularly find coatings applied over friable mortar that failed within a season and hid the damage underneath. We won’t recommend a rebuild without showing you the evidence. Call (833) 350-7109 and we’ll take a look.
Yes, and that’s the right spec for these stacks. Elkins Park’s older homes have rectangular clay tile flues in nonstandard sizes, often several in one stack. A multi-flue cap is built to the actual tile dimensions, so the corners seal and nothing gets in. A round cap forced onto a rectangular tile leaves gaps. We measure the tile and order the cap fitted to it. Call (833) 350-7109 for a quote.
No, a spalling crown repair is normally fine. The historical society’s guidance is about discouraging exterior alterations, not about leaving a crown to fail. Rebuilding a crown with a proper overhang and expansion joint restores the chimney without changing its facade. On many Elkins Park stacks we can do the work from the inside. We’ll walk you through what’s visible and what isn’t. Call (833) 350-7109.
Yes, a properly fitted cap is the main defense. An unlined flue with an open top is a direct path for squirrels, birds and leaf fall, and Elkins Park’s tree cover makes that a real problem in fall. A cap sized to the flue opening closes that path while still letting the flue vent. We fit caps to the actual tile, not a generic cover. Call (833) 350-7109 for an exact quote.
Book a Cap or Crown Visit in Elkins Park
If your crown is cracked, your cap doesn’t fit, or you’ve just bought an older Elkins Park home and want to know what’s up there, call Chimney Sweep Bustleton at (833) 350-7109. We’ll scan the flue, show you what we find, and give you a written estimate before any work is booked. Our technicians have up to 9 years of experience, and we handle the full system: chimney cap & crown, sweep, liner, rebuild and fireplace repair. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Bustleton.